S78-11-06 Inflatable Spring Damping Pad Iron

S78-11-06 Inflatable Spring Damping Pad IronScope of application:
Precision equipment such as small and medium-sized high-speed presses and three seater coordinate measuring instruments.
Application: Small and medium-sized high-speedpress、Coirdinate measuring machine and others precision equipments.

S78-11-06 Inflatable Spring Damping Pad IronProduct Features:
Installing the machine tool does not require burying anchor bolts, shortening the installation cycle and saving installation costs.
According to changes in production processes, adjust the position of machine tools at will to achieve flexible design of production flow.
Adjusting the level of the machine tool is convenient and quick.
Low natural frequency, isolation, vibration reduction, and noise reduction.
Strong oil resistance and corrosion resistance.
Feature of product:1.Machines are stationary on floor without anchors. Therefore the cost and time of installation can be greatly saved .2.It is convenient and quick to adjust the level of machine .3.The layout of machines can be changed freely according to the modification of manufacturing process. So it is easy to design the flexible production line .3.Vibration and nosie can be reduced and isolated by using this product.4.It can resist oil and corrosion greatly.

Usage of S78-11A series:
How to use:
1. Lift the machine tool to a distance of 110mm to 150mm from the ground, place the pad iron under the machine tool, and gradually fill it with gas in a diagonal manner from 0.1 Mp, 0.2 Mp... until the internal pressure reaches 0.4Mp to 0.6Mp. Use a tire pressure gauge to check the internal pressure of the pad iron.
2. The height of the pad iron is 87 ± 3mm from the top surface of the pad iron to the top of the bottom plate. Test data shows that at this height, the internal pressure, load-bearing capacity, and vibration reduction effect of the pad iron reach the desired state.
3. If the shim is not used for a long time, the gas inside the shim can be released and refilled when in use.
1. Lift the machine to 110-150mm high above from the ground, place the mount under the machine, and gradually pressurize it with air by 0.1Mp, 0.2Mp…, the two mounts on one diagonal should be pressurized equally, until the inner air pressure reach 0.4Mp-0.6Mp. Then check the inner pessure of the mount with a tire pressure meter.
2. The best height between the top surface and bottom of the mount is 87±3mm. Test figures shows that the inner pressure, the resisting load and the mounting effect can achieve the best situation at this height.
3.When the mount is not used for a long time, it can be deflated, and repressurized before use.

Installation precautions for S78-11A series:
Note for installation:
1. Before installing the pad iron, the center of the load must be identified. The pad iron must be symmetrically configured and the appropriate model should be selected according to the bearing value.
2. Try to maintain the same height for the same type of shim.
3. During the transportation process, handle with care to avoid damaging the valve and causing air leakage.
4. If you need to move the position of the machine tool, you must first release the gas inside the shim to prevent the rubber part in the shim from cracking due to high internal pressure.
1. Before installation, first find out the barycentre of the load. The mounts must be symmetrically installed. Choose the suitable type according to the weight of the load.
2. Mounts of the same type should be adjusted to the same height.
3. Be careful when portage, lest the damage of the valve cause air leakage.
4．If the machine needs to be moved, deflate the mounts first, lest the rubber part blows out because of the strong inner pressure.

Technical parameters and selection table:

Specification and chart for choice: